Replacement lamp for Sidel blowing machine

Thu, 09 Jul 2026 07:20:19 +0800

Introduction

We built this replacement lamp to slide right into your Sidel blowing machines and Husky HyPET high-speed lines. Its one job? Hit the PET preform with focused, serious heat. The whole point is simple: pack a ton of heating power into a small space, so the preform is perfectly ready for the stretch blow step—without scorching the surface.

The Power Behind the Heat

This lamp is all about high-power density. It runs at 400V, pulls 2500W, and concentrates all that energy across a 300mm tube. That power-to-length ratio is exactly what you need to drive heat through the PET wall fast. On a fast-moving HyPET line, the preform is racing past. You need a lamp that hits target temperature in milliseconds, not seconds, just to keep up. But here’s the catch: that kind of power creates serious heat. Make sure your machine’s cooling system is up to the task. If it isn’t, the lamp and nearby parts will run too hot, and you’ll shorten their lifespan.

PET blowing machine ceramic parts

Wed, 24 Jun 2026 03:19:44 +0800

On the blow molder, uneven preform heating shows up immediately—off-center walls, blown threads, and scrap that chews straight through margin. When the heating tunnel is fighting you, you don’t need another lecture on how to run the machine. You need parts that drop in and deliver repeatable heat, period. What matters, technically We build ceramic infrared emitters for PET stretch blow molding, with spectral control that lines up with preform absorption. The specs match OEM requirements: 1200–1500 W, 230 V, and standard R7s connectors so the retrofit is plug-and-play. The ceramic body takes thermal shock without cracking, and it holds output stability through long runs. We control lamp-to-lamp variance and ship matched sets so the heating profile across the tunnel stays consistent. Why this plays in your plant In your operation, consistency is measured in seconds and grams. With matched ceramic emitters, preform heating repeats—fewer temperature swings, less scrap. That means more stable cycles, fewer line stops, and energy use you can plan around. You pay once for replacement parts and get OEM-level performance without the OEM price tag—engineered from an OEM baseline, delivered at a direct price. A few shop-floor notes Installation is straightforward, but the heating zone needs clean reflectors and proper alignment. After the swap, run a baseline profile and re-tune the PID to match the emitter’s response. Ceramic emitters aren’t universal. Tell us the machine brand and tunnel configuration, and we spec the right length, wattage, and lead-wire details so it fits the first time.

Blowing on Warm IR Radiant Heating

Replacement lamp for Sidel blowing machine

Introduction

The Power Behind the Heat

PET blowing machine ceramic parts